Products
Gravure Cylinder Cleaner
- One-component inks can be cleaned in less than 2 minutes, and two-component inks can be cleaned in 6 minutes if left for less than 1 hour.
- Flange surface can also be cleaned.
- This single unit can handle cylinder plates from 700 to 1350 mm.
- No need to wash the plate while it is still attached to the printing press, and the ink is not diluted, making it easier to formulate the ink.
- Energy saving 850VA, runs on 18 to 30 liters of small volume fluid.
- Anilox rolls can also be cleaned
- Pattern cells and flanges are cleaned at the same time
- Each cylinder takes approximately 2 minutes to clean.
- Complete cell cleaning to ensure print quality
Cell (plate)
Before washing
After washing
Flange (end face)
Before washing
After washing
SAWA | シリンダー洗浄機 SC-G100 洗浄動作
| model number | SC-G100 |
|---|---|
| Dimensions and weight | W: 2,769 x D: 970 x H: 1,375 mm (including protrusions) Approx. 450 kg |
| Input power and current | AC 100 V 50/60 Hz 900 VA |
| Ultrasonic frequency | 40 kHz, 600 W |
| Input Air | 0.5 MPa, 770 NL/min |
| Exhaust Duct | Wind speed 5m/sec Duct diameter φ148 |
| Supported rolls | Overall length 700~1,350 mm Circumference 345~942 mm |
Specifications and appearance are subject to change without notice for improvement.